Torque Slip Characteristics
Torque slip characteristics in an induction motor are also known as torque-speed characteristics. They provide us with information about the variation of torque with the slip. And the variation of the slip obtained with the variation of speed. When the speed varies, the slip varies, and in contrast, the torque will also vary.
To understand the torque slip characteristics of induction motor, we should focus on mathematics relations. And from this relation, we deduce that curve. This curve provides us with information about the operation of an induction motor.
At the synchronous speed slip =
So, the motor will produce zero torque. We have nearly a linear relationship between the torque and the slip in normal operating conditions (between pullout speed and synchronous speed). Also, the maximum torque induced ranges from a higher speed.
And we can’t deny that the torque is affected by differentiating the rotor resistance. Changing the rotor resistance will affect the slip. When we have a constant rotor reactance, we would have maximum torque at the start by adding much resistance in the rotor.
Torque Slip Characteristics of the Three-phase Induction Motor
Torque-slip characteristics of the three-phase induction motor do not have a big difference from the main induction motor. We only have three regions or three cases to illustrate and predict variation, and they are:
- Generating mode(Low slip region)
- Motoring mode (Medium slip region)
- Breaking mode (High slip region)
Generating Mode (low slip region)
In this mode, the motor runs at speed above the synchronous speed, and a prime mover drives it.
We supply the stator with a three-phase supply that supplies electrical energy.
In this case, we have a negative slip and torque, so the motor receives mechanical energy to deliver electrical energy.
In generation mode, we require reactive power from an outside supplier to operate the motor; so, we don’t usually use the induction motor as a generator.
Motoring Mode (medium slip region)
In this mode, we supply the stator with voltage, and the motor rotates below the synchronous speed.
The slip varies from zero at no load to 1 at a standstill; so, the torque varies from zero to the full load torque.
That means the torque is directly proportional to the slip; The more slip we have, the more torque will be produced and vice versa.
Breaking Mode (high slip region)
In braking mode or plugging, the polarity of the supply voltage is changed, so the motor rotates in the reverse direction, and as a natural result, the motor will stop.
We only use this method when we want to stop the motor within a very short period.
And we try to disconnect the stator from the supply before the motor enters this braking mode. Because the kinetic energy stored in the revolving load dissipated as heat.
If the stator is still connected, the motor receives power, which is also dissipated as heat. So, in this case, the motor would develop enormous heat energy.
Torque Slip Characteristics of Single-phase Induction Motor
In the single-phase induction motor, we have forward and backward fields. In unity slip, the forward and the backward field produce equal torque but in the opposite direction. So, the produced net torque equals zero, so the motor fails to start.
The single-phase induction motor is not self-starting. To start the motor or to have a starting torque, we can increase the motor’s forward speed. Hence the forward slip and the reverse torque will decrease, and the forward torque will increase, which makes the motor start.
That means there would be a difference of torque between the forward and backward fields to start the single-phase motor.
When we have a larger forward field torque than the backward field torque, the motor rotates in a forward (anti-clockwise) direction. When we have a larger backward field torque than the forward field torque, the motor rotates in a backward (clockwise) direction.